Load Master II
Evolution of our best selling Load Master!
New and improved!
Clamping motor mounts
Wires exit the front of the unit instead of above the motors
Resistors now inside the base, but still replaceable or interchangeable with tuning options sold separately
This is a device to be used with a motor analyzer to measure how your motor would work in real world conditions (like when its on the track).
Please note that we recommend using the same turn slave motor or the next higher turn (if wanting to test a 21.5 motor use a 25.5 or 21.5 motor). This is only rated for use with 25.5, 21.5, 17.5 and 13.5 motors, it is not recommended for use with any lower turn motors. If you would like to use a lower turn motor with these please message us.
An additional note. Some 13.5 in operation with the tunalyzer and the load master, causes too many amps to be pulled and cannot be used without the separate tuning options. We have not found this issue with the motolyser.
Features & Specifications:
Plugs into any current analyzer
Color coded wires to identify A, B and C poles
Vented sides
8" motor wires and 275mm sensor wire included
Resistor bank and coupler
Rated for up to 120* Fahreinheit
Handcrafted in the USA!
Includes:
1, dual motor stand
1, coupler (to attach the test motor to the slave motor)
1, 3 input resistor bank (to simulate a load)
1, 275mm sensor wire
Needed to use:
Motor analyzer
Test motor
Slave motor
Power source
Check out their Initial video below, as well as their tips video. Additional videos located on their Youtube Channel.
