Tired of charge leads breaking? We are too! These offer superior protection for all of your charging needs!
Designed to be used with Amass standard xt60 female connectors
Features:
- Chemical and temperature resistant
- Made out of a proprietary material (NOT PLA)
- Designed to be easy to plug in and remove
- Secure bond for use over time
- 18 months of research and development
Notes:
These are designed to be use with fully protected leads, but can be used with charge leads without sheathing at the connectors. Can fit 10 or 12 awg wire
How to use:
Make sure your wires are soldered within the solder area. Slide protector on ensuring polarity is correct. Slide the protector down, apply a small amount of glue on the sheathing, and flat worded part of the connector. Slide protector up, and push until it snaps. Apply a small amount of glue from the wire side, to backfill if needed.
What's included:
4 xt60 protectors
Check out how to apply them:
