Tired of charge leads breaking? We are too! These offer superior protection for all of your charging needs!
Designed to be used with DRC connectors, but they will work standard 4mm connectors as well.
Features:
- Chemical and temperature resistant
- Made out of a proprietary material (NOT PLA)
- Designed to be easy to plug in and remove
- Secure bond for use over time
- 18 months of research and development
Notes:
These are designed to be use with fully protected leads, but can be used with charge leads without sheathing at the connectors. Please use 12 awg size if your charge leads do not have sheathing down to the connectors.
How to use:
Make sure your wires are soldered within the solder area. Test fit before applying heat shrink. Apply heat shrink with heat gun or lighter. Let the heat shrink cool, and test fit the protector again. Slide the protector down, and generously apply glue to the bottom half of the protector. Place wire in and apply glue to the top of the heat shrink/connector. Snap top protector on, gently twist and inspect to make sure the protector is fully snapped together.
What's included:
4 4mm positive tops and bottoms w/ red adhesive heat shrink
4 4mm negative tops and bottoms w/ black adhesive heat shrink
Check out how to apply them:
